Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Get your free estimateGarage Door Company in Florence-Graham, CA
Garage door installation in Florence-Graham means working with homes built between the 1920s and 1950s, most of which have detached garages on nonstandard openings, accessed from narrow alleys or side drives. We’re Onyx Garage Door Service, and we’ve served Florence-Graham since 2014, installing, repairing, and re-powering doors across ZIP 90001. Call (877) 588-8251 when you need a technician who understands that a Florence-Graham garage is rarely a standard 16-foot front-facing door.
Why Florence-Graham Homes Are Different
Florence-Graham is one of the densest, most heavily renter-occupied communities in unincorporated South Los Angeles. The housing stock is overwhelmingly small 1920s to 1950s single-story stucco bungalows and modest duplexes packed tightly onto small lots. Your garage likely sits detached at the back of the lot, reached via a narrow side drive or rear alley rather than facing the street. That changes everything about how a garage door job gets done.
We regularly work on alley side access behind Grape Street and the small commercial strips off Florence Avenue, where parked cars and trash bins can block a job for an hour. Many of these detached garages were built as cheap accessory structures long before standardized door sizing existed. We routinely see 7-foot and 8-foot openings trimmed out to odd widths, low headroom that rules out certain openers, and framing that has shifted so far out of square that standard track brackets will not sit flush.
The climate adds another layer. Mild and dry means no snow or freeze damage, but the intense summer sun bakes west and south facing garage doors daily. Wood panels warp and fade. Torsion springs fatigue faster in the heat. The air quality and dust in this part of South LA grit up tracks and rollers, so a door that worked fine six months ago can start grinding and binding with no obvious cause. We account for all of that before recommending any repair or replacement.
Styles & brands we work with
Our Main Florence-Graham Services
Most calls we take in Florence-Graham fall into two categories: a door that has physically failed and an opener that has stopped responding. Here is what those jobs involve in this neighborhood specifically.
Garage Door Repair in Florence-Graham
In Florence-Graham, a garage door repair usually means a torsion spring that snapped in the heat or a cable that jumped a drum on an older door with nonstandard hardware. The detached garage setup here adds a wrinkle: many homeowners do not use the door daily, so a failure can go unnoticed for days or weeks. That means more corrosion, more seized rollers, and more track realignment work by the time we arrive. We diagnose the full system, door, hardware, and opener together, because on these older Florence-Graham garages one failure often points to another. Read more about what a repair visit covers on our Garage Door Repair in Florence-Graham page.
Garage Door Opener Repair in Florence-Graham
Openers in Florence-Graham are often mounted in low-headroom positions on ceilings that were never framed with a motor in mind. That creates a particular failure profile: stripped gears from doors that bind, overheated motors from sun soaked garages with no ventilation, and logic boards that fail after years of power surges through older unincorporated-area wiring. We work on LiftMaster, Chamberlain, Genie, and Craftsman openers, so whatever is mounted above your door, we already know its quirks. See our dedicated Garage Door Opener Repair in Florence-Graham page for the full breakdown.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Garage Door Installation in Florence-Graham
Installing a garage door in Florence-Graham is rarely a simple swap. Most of these detached garages predate 1960, and many openings were framed to whatever dimensions the original builder had on hand. A new door often needs custom width adjustments, new jambs, or track relocation to work properly. The informal conversion economy shapes this market too: countless Florence-Graham garages have been quietly converted to living space or storage, so a new door is frequently bought for security, ventilation, or sealing rather than curb appeal. We handle the full scope, from measuring a nonstandard opening to hanging a new door, through Garage Door Installation from the Onyx service line.
Garage Door Replacement
Signs you need it
Your current door is a warped wood panel from the 1950s, the bottom section has rotted or been kicked in, or the door no longer seals enough to keep dust and alley air out of a converted garage space.
What it costs in Florence-Graham
A full new door installation in Florence-Graham typically runs $700 to $2,200 depending on door size, material, insulation, and whether the opening needs reframing.
How we do it
We measure the existing opening, verify headroom and side clearance for the track system, quote the job at a fixed price, then remove the old door, install new jambs if needed, hang the new door, and balance the springs before testing the full travel.
Garage Door Installation Service
Signs you need it
You need a door hung on a new conversion, an addition, or a garage built without a functioning door, and the opening is not a standard big-box size.
What it costs in Florence-Graham
Expect $700 to $2,200 for a complete new installation in Florence-Graham, with the final figure driven by opening size, low-headroom requirements, and whether new track and hardware must be supplied.
How we do it
We frame-check the opening, confirm the right door spec for the space, assemble and hang the door sections, set the track, install and balance the springs, and mount and program the opener if one is part of the job.
Garage Door Seal Installation
Signs you need it
You can see daylight or feel drafts under the door, dust or water blows in from the alley, or the old rubber bottom seal has cracked and separated from the retainer.
What it costs in Florence-Graham
Seal installation in Florence-Graham falls within the broader garage door repair range of $150 to $600, depending on whether we are replacing just the bottom seal or also side and top weatherstripping.
How we do it
We pull the old seal from the retainer, clean out debris and rust, cut a new seal to the door width, feed it through the retainer or fasten a new retainer if needed, then check the full perimeter for air gaps.
What Garage Door Installation Costs in Florence-Graham
| Item | Typical range in Florence-Graham |
|---|---|
| New door installation | $700 – $2,200 |
| Panel replacement | $250 – $500 |
| Track realignment | $120 – $240 |
How long does a Florence-Graham garage door installation take?
Most single-door replacements take four to six hours on site. A nonstandard opening that needs reframing or low-headroom track work can push into a second day, particularly when we are working from an alley with limited tool access.
Can you install a door on my converted garage?
Yes. We regularly install doors on converted garages in Florence-Graham where the priority is security, sealing, or ventilation rather than vehicle access. We will spec the door and seal package to match how the space is actually used. Call (877) 588-8251 for a free measure.
Brands We Service in Florence-Graham
We work on your brand, not just our preferred one. In Florence-Graham we carry parts and know the quirks of LiftMaster, Chamberlain, Clopay, and Genie systems, which covers the majority of doors and openers in these older detached garages. Most repairs are completed in a single visit because the correct part is on the truck. See our brands for the full list.
See the difference
Before
After
Before
After
Before
AfterPricing for Garage Door Company in Florence-Graham, CA
| Service | Typical range in Florence-Graham |
|---|---|
| Spring repair | $180 – $340 |
| Cable repair | $130 – $250 |
| Opener repair | $120 – $320 |
| Opener installation | $250 – $550 |
| Panel replacement | $250 – $500 |
| Track realignment | $120 – $240 |
| Roller replacement | $110 – $220 |
| New door installation | $700 – $2,200 |
| General garage door repair | $150 – $600 |
Two things push price up in Florence-Graham: nonstandard opening sizes that require custom door widths or reframing, and alley-side access that makes material handling slower. Whatever the job, we quote the full price and get your agreement before any work starts. No surprise invoices.
Neighborhoods We Serve in Florence-Graham
We work across all of Florence-Graham and the immediate blocks of ZIP 90001, from the streets running off Florence Avenue to the residential blocks east of Alameda and the lanes around Graham Avenue. Most calls get a same-day or next-day visit depending on the time of the call.
- Florence Avenue corridor
- Graham Avenue blocks
- Grape Street area
- East Florence-Graham near Alameda
- Miracle Mile adjacent blocks off Central
Service Area – Cities Near Florence-Graham
Onyx Garage Door Service is based in South Gate, and we cover Florence-Graham plus the surrounding unincorporated and incorporated communities across South LA. If you are in a neighboring city and need the same brand-specific service, we also cover Huntington Park, CA, Walnut Park, CA, our home base of South Gate, CA, and Bell, CA.
Serving Florence-Graham, CA — Our Local Coverage Area
We’re based in the Florence-Graham area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Garage Door Company in Florence-Graham
Most Florence-Graham calls get a same-day or next-day visit depending on the time of day you call and whether your door is on the alley or street side. Emergency spring and cable failures are prioritized because a broken spring leaves the door unsafe to operate. Call (877) 588-8251 and we will give you a straight arrival window.
For a like-for-like door replacement on an existing opening, no permit is generally required in unincorporated LA County. If your project changes the opening size or involves structural reframing, a permit may apply. We handle the full installation scope and can tell you upfront whether your specific job triggers anything beyond the door itself.
We work alley-side jobs in Florence-Graham every week. We carry our tools and door sections to the garage, so a truck that cannot reach the door is a scheduling detail on our end, not a problem for you. Just let us know the access situation when you call and we will plan the visit accordingly.
What happens when you call
- 1A real person answersNo phone trees — talk to a local garage door pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Florence-Graham Customers Say
"Replaced the bottom panel after I backed into it. Color match is close enough that you have to know to look for it."
— Henry Nguyen"Spring snapped at six in the morning with my car sealed inside and me due at work. Somebody was here by eight thirty with the right spring on the truck. Door's quieter now than it was before it broke."
— Luis Mendoza"Door installed in about four hours, old one hauled away, and he stayed to program both cars and the wall panel before he left."
— Steven Lin